CAT C9 Parts Manual

SEAL-O-RING (FUEL SYSTEM)

PLATE & FILM GP (ENGINE INFORMATION) CONTACT YOUR LOCAL DEALER INSTALL CENTERED ON VALVE COVER VIEWED FROM LEFT SIDE THIS LABEL WILL BE TO THE LEFT OF THE IMO LABEL AND TO THE RIGHT OF THE OIL FILL. PUT EXTRA LABEL IN PLASTIC BAG ATTACHED TO ENGINE. INSTA

FILM-ENGINE OIL INSTALL ON TOP OF VALVE COVER ON LEFT REAR ANGLED FLAT SURFACE. NEAR OIL FILL CAP.

FILM-INFORMATION (ENGINE OIL)

FILM-ENGINE OIL INSTALL ON OIL FILTER BASE ABOVE AND TO THE RIGHT OF OIL FILTER AS ON CURVED SURFACE, READABLE FROM RH SIDE OF ENGINE.

SEAL-O-RING (FUEL SYSTEM)

BEARING-MAIN

SEAL-O-RING (CYLINDER HEAD)

SEAL-LINER

SEAL-LINER FOR A LIST OF RELATED PARTS THAT MAY BE REQUIRED FOR THE ENGINE REBUILD TO THE KIT CONSIST, PLEASE VISIT HTTP://DEALER.CAT.COM/RELATED

ROD AS (PISTON)

RING-PISTON (INTERMEDIATE)

SEAL-VALVE STEM

PIN-PISTON

RING-PISTON (OIL CONTROL)

SEAL-O-RING (FUEL SYSTEM)

BOLT (M16X2X160-MM)

FILM GP (CERTIFICATION) CONTACT YOUR LOCAL DEALER INSTALL ON TOP OF VALVE COVER READABLE FROM LH SIDE OF ENGINE. THIS WILL BE INSTALLED BETWEEN THE ENGINE INFO AND EPA LABEL. INSTALL LAMINATE OVER SILVER FILM.

SEAL-O-RING (CYLINDER HEAD)

BOLT (M16X2X180-MM)

GASKET AS

VALVE-INLET

VALVE-EXHAUST

SPRING-VALVE (INNER)

SPRING-VALVE (OUTER)

FILM GP (SERIAL NUMBER PLATE) CONTACT YOUR LOCAL DEALER

CROWN AS-PISTON

RING-PISTON (TOP)

KEY-WOODRUFF

BEARING-SLEEVE (CAMSHAFT)

BEARING-SLEEVE (CAMSHAFT)

GEAR AS-IDLER (50-TEETH)

RETAINER (VALVE)

BEARING (PISTON)

CYLINDER HEAD AS

BEARING-SLEEVE (CAMSHAFT)

SEAT-VALVE SPRING (VLV SPRING)

GEAR (100-TEETH)

FILM-WARNING (DO NOT USE ETHER, U.S) INSTALL CENTERED ON AIR CLEANER COVER

FILM-WARNING (HOT FLUID UNDER PRESSURE, U.S.) INSTALL ON TOP FLAT SURFACE OF EXPANSION TANK TOWARD FRONT OF ENGINE.

FILM-WARNING (READ OMM) INSTALL ONE ON LH SIDE OF ENGINE ON VERTICAL SURFACE OF FRONT FIRST RAISED SECTION OF VALVE COVER. INSTALL ONE ON RH SIDE OF ENGINE ON VERTICAL SURFACE OF SECOND RAISED SECTION OF VALVE COVER FROM THE REAR OF THE ENGINE.

FILM-WARNING (DO NOT OPERATE, READ OMM)

FILM-WARNING (DO NOT OPERATE, READ OMM) INSTALL ONE EACH SIDE OF ENGINE ON VERTICAL SURFACE OF VALVE COVER.

FILM-STRIPE (CAT, C9, ACERT) INSTALL ON TOP FLAT SURFACE OF VALVE COVER CENTERED IN MIDDLE DEPRESSION. READABLE FROM RH SIDE OF ENGINE.

FILM-NOTICE (LIFT EYE LOCATION) INSTALL ON INSIDE SURFACE OF LIFTING EYES, JUST BELOW EYES.

BOLT-SOCKET HEAD (M8X1.25X65-MM)

SKIRT-PISTON

TURBOCHARGER GP

INJECTOR GP-FUEL

PLATE-THRUST