PLATE-SERIAL NUMBER (ENGINE) CONTACT YOUR LOCAL DEALER. REFLATTEN AFTER STAMPING INSTALL ON LH SIDE OF BLOCK NEAR REAR FACE ON CAMSHAFT COMPARTMENT USING 7B-3028 DRIVE SCREWS. STAMP SERIAL NUMBER IN BLOCK JUST BELOW PLATE IN FIGURES 6 HIGH.

FILM-FUEL RETURN (EXCESS) INSTALL FILM ON FUEL RETURN VALVE OR THE FUEL FILTER HOUSING.

FILM-INFORMATION (STANDARD ROTATION) INSTALL FILM ON THE LH CAM GEAR COVER IN A VISIBLE LOCATION, IF THAT COVER IS NOT AVAILABLE MOVE TO THE RH CAM GEAR COVER.

FILM-ROTATION (STANDARD ROTATION) INSTALL ON RH OR LH REAR ACCESSORY DRIVE COVER.

FILM-WARNING (HOT SURFACE) INSTALL FILM ON THE VALVE COVERS FOR CYLS. #13 AND #14. IF EITHER OF THESE COVERS ARE NOT AVAILABLE, MOVE FILM TO THE NEXT AVAILABLE VALVE COVER NEAREST TO THE TURBOCHARGER, VISIBLE FROM THE SIDE OF THE ENGINE.

FILM-WARNING (NO WELD, READ OMM) INSTALL ONE FILM ON EACH SIDE OF THE ENGINE, ONE FILM ON TOP OF THE POWER DISTRIBUTION BOX, AND ONE FILM ON THE OPPOSITE SIDE OF THE ENGINE, CENTERED ON THE FIRST VISIBLE SIDE COVER FROM THE REAR OF THE ENGINE. IF THERE IS

FILM-WARNING (HOT FLUID UNDER PRESSURE, U.S.) INSTALL FILM ON THE TOP OF THE EXPANSION TANK, CENTERED WITH THE FILL CAP ON THE RH SIDE.

FILM-WARNING (DO NOT OPERATE, READ OMM) INSTALL ONE FILM ON CYLS. #1, #2, #15 AND #16 VALVE COVER BASES, OR THE NEXT VISIBLE VALVE COVER BASES.

PLATE & FILM GP (ENGINE) CONTACT YOUR LOCAL DEALER. INSTALL FILM ON THE LH, FRONT, LOWER HEAD FACE OF THE BLOCK BETWEEN CYL. #2 AND THE FRONT HOUSING, READABLE FROM THE REAR OF ENGINE. INSTALL CLEAR LAMINATE OVER FILM.

PLATE-IDENTIFICATION (CATERPILLAR) INSTALL EACH ONE ON A VISIBLE CAMSHAFT COVER ON LH AND RH SIDES OF ENGINE.

PLATE-IDENTIFICATION (CAT) INSTALL ONE ON RH REAR CAM COVER AND ONE ON THE LH FRONT CAM COVER IF VISIBLE. IF EITHER PRIMARY LOCATION IS NOT VISIBLE, INSTALL PLATE ON THE NEXT VISIBLE CAM COVER LOCATION ON THAT SIDE OF THE ENGINE.

SCREW-DRIVE (NO 4X3/16-IN) INSTALL ENGINE SERIAL NUMBER PLATE.

STRAP-CABLE INSTALL PRESTART TAG.