| Part No. | Name | Qty | Page |
|---|---|---|---|
| 106-8602 |
FILM (COOLANT INFORMATION) INSTALL ON TOP CENTER SURFACE OF EXPANSION TANK OR HEAT EXCHANGER. FILM GP (EPA CERTIFICATION)
|
1 | 350 |
| 7E-8050 |
CONTACT YOUR LOCAL DEALER. INSTALL IN A VISIBLE LOCATION ON THE TUBING FROM THE SEA WATER OUTLET TO THE AFTERCOOLER INLET. WITH SERIAL NUMBER POSITIONED IN THE UPPRER RIGHT HAND CORNER. INSTALL LAMINATE 178-0478 OVER FILM.
|
1 | 350 |
| 233-0060 |
FILM-NOTICE (LIFT EYE LOCATION) INSTALL ON INSIDE SURFACE OF LIFTING EYES, JUST BELOW EYES.
|
2 | 350 |
| 228-3581 |
FILM-WARNING (DO NOT OPERATE, READ OMM) INSTALL ONE ON THE LH AND RH VALVE COVER BASE TOWARDS FRONT OF ENGINE. ON TOP SURFACE OF INSTRUMENT PANEL BOX.
|
2 | 350 |
| 224-8945 |
FILM-WARNING (DO NOT USE ETHER, U.S.) INSTALL CENTERED ON AIR CLEANER COVER IF APPLICABLE.
|
2 | 350 |
| 225-4257 |
FILM-WARNING (HOT FLUID UNDER PRESS) INSTALL ON TOP SURFACE OF EACH EXPANSION TANK OR HEAT EXCHANGER.. PLATE & FILM GP (ENGINE INFORMATION)
|
2 | 350 |
| 3N-3790 |
CONTACT YOUR LOCAL DEALER. REFLATTEN AFTER STAMPING. INSTALL ON LH SIDE OF BLOCK NEAR FRONT FACE AT BOTTOM OF WATER JACKET USING LOCTITE COMPANY DEPEND ADHESIVE. STAMP SERIAL NUMBER IN BLOCK JUST BELOW PLATE IN FIGURES 6 HIGH.
|
1 | 350 |
