CAT C13 Parts Manual

HOLDER-FUSE

PLATE & FILM GP (ENGINE) (ENGINE RATING)(GLPS) INSTALL ON RH SIDE OF ENGINE ON FRONT HALF OF INTAKE MANIFOLD AS HIGH AS POSSIBLE ON VERTICLE SURFACE INSTALL LAMINANT OVER SILVER FILM, SUCH THAT BOTTOM EDGE OF FILM IS COVERED

FILM-INFORMATION (3176-IND MAINT) (C13 IND)

PLATE (MANUFACTURING INFORMATION) INSTALL ON RH OR LH SIDE ENGINE IN A VISIBLE LOCATION. DO NOT INSTALL ON FRONT OR REAR OF ENGINE OR COMPONENT

SEAL-O-RING

WATER SEP & FUEL PRM PUMP GP

SPACER (8.5X12.7X38.2-MM THK)

SPACER (8.5X12.7X87.3-MM THK)

BOLT (5/16-18X2.25-IN)

FILM-WARNING (READ OMM)

PLATE (C13 ACERT) INSTALL ON CENTER OF VALVE COVER TO READ FROM LEFT SIDE OF ENGINE

FUSE (5-AMPERE)

LOCKWASHER

TAG-INSTRUCTION (ENGINE PRESTART) INSTALL ON RH OR LH SIDE ENGINE IN A VISIBLE LOCATION. DO NOT INSTALL ON FRONT OR REAR OF ENGINE OR COMPONENT

PLATE-SERIAL NUMBER (ENGINE) INSTALL WITH LOCTITE COMPANY DEPEND ADHESIVE ON RH SIDE OF CYL BLOCK

PLATE-SERIAL NUMBER (ENGINE)

NUT-HEX (15/32-32-THD)

LOCKWASHER

RING-LOCKING

NUT (5/16-18-THD)

SCREW-MACHINE (6-32X0.25-IN)

FILM (LABEL-AIAG SHIPPING) ATTACH TO GOVERNOR AND COMPRESSOR LINES ON FRONT OF ENGINE

FILM (INFO) (ENGINE SERIAL NUMBER BAR CODE) INSTALL ON LH SIDE OF VALVE COVER BASE JUST FORWARD OF THE BREATHER.

BOLT (5/16-18X4.25-IN)

STRAP-CABLE (FOR ENGINE PRESTART TAG)

MOUNT-ISOLATION

SWITCH AS-TOGGLE (PRIMING PUMP)(ON/OFF)

WASHER-HARD (8.8X25.5X2-MM THK)

PLUG

FILM-WARNING (ELECTRICAL SHOCK HAZARD) *** REQUIRES 2 PER ENGINE *** INSTALL ONE TOWARDS FRONT AND ONE TOWARDS REAR OF ENGINE ON LH AND RH SIDES OF VALVE COVER BASE.