| 零件号 | 零件名称 | 数量 | 页码 |
|---|---|---|---|
| 8L-9765 |
FILM-FUEL RETURN (EXCESS) INSTALL FILM ON FUEL RETURN VALVE OR THE FUEL FILTER HOUSING.
|
1 | 689 |
| 5P-1175 |
FILM-IDENTIFICATION (ENGINE OIL FILL) INSTALL FILM ON THE TOP OF THE OIL FILL CAP CENTERED BETWEEN THE HANDLE AND THE TOP EDGE OF THE OIL FILL CAP.
|
1 | 689 |
| 250-3444 |
FILM-INFORMATION (STANDARD ROTATION) INSTALL FILM ON THE LH CAM GEAR COVER IN A VISIBLE LOCATION, IF THAT COVER IS NOT AVAILABLE MOVE TO THE RH CAM GEAR COVER.
|
1 | 689 |
| 308-4479 |
FILM-WARNING (NO WELD, READ OMM) INSTALL ONE FILM ON EACH SIDE OF THE ENGINE, ONE FILM ON TOP OF THE POWER DISTRIBUTION BOX, AND ONE ON THE OPPOSITE SIDE OF THE ENGINE, CENTERED ON THE FIRST VISIBLE SIDE COVER FROM THE REAR OF THE ENGINE. IF THERE IS NO P
|
21 | 689 |
| 225-3227 |
FILM-WARNING (HOT SURFACE) INSTALL ONE FILM ON THE RH SIDE ON THE OIL COOLER, ABOVE THE DIPSTICK, AND ONE FILM ON THE LH SIDE OF THE ENGINE, ON THE CRANKCASE COVER NEAR THE MIDLINE OF THE ENGINE, BOTH FILMS SHOULD BE VISIBLE FROM THE SIDE OF THE ENGINE.
|
2 | 689 |
| 225-4256 |
FILM-WARNING (HOT FLUID UNDER PRESSURE, U.S.) INSTALL FILM ON THE TOP OF THE EXPANSION TANK CENTERED WITH THE FILL CAP ON THE RIGHT SIDE.
|
1 | 689 |
| 233-6084 |
FILM-WARNING (FIRE, STOP ENGINE, DO NOT OPEN) INSTALL ONE FILM ON THE RH AND LH SIDES OF THE ENGINE NEAR THE TOP OF THE CRANKCASE COVERS NEAREST THE CENTERLINE OF THE ENGINE VISIBLE FROM THE SIDE OF THE ENGINE, DO NOT INSTALL ON THE EXPLOSION RELIEF VALVE
|
2 | 689 |
| 225-3226 |
FILM-WARNING (HOT SURFACE) INSTALL FILM ON THE VALVE COVERS ON CYLS. #13 AND CYL #14. IF EITHER OF THESE COVERS ARE NOT AVAILABLE, MOVE FILM TO THE NEXT AVAILABLE VALVE COVER NEAREST TO THE TURBOCHARGER, VISIBLE FROM THE SIDE OF THE ENGINE.
|
2 | 689 |
| 115-5852 |
PLATE & FILM GP (ENGINE INFORMATION) CONTACT YOUR LOCAL DEALER. INSTALL FILM ON LH, FRONT, LOWER HEAD FACE OF THE BLOCK BETWEEN CYL. #2 AND THE FRONT HOUSING, READABLE FROM THE REAR OF ENGINE. INSTALL CLEAR LAMINATE OVER FILM.
|
1 | 689 |
| 298-5631 |
PLATE-IDENTIFICATION (CAT)
|
2 | 689 |
| 3N-3790 |
PLATE-SERIAL NUMBER (ENGINE) CONTACT YOUR LOCAL DEALER. REFLATTEN AFTER STAMPING. INSTALL ON LH SIDE OF BLOCK NEAR REAR FACE ON CAMSHAFT COMPARTMENT USING 7B-3028 DRIVE SCREWS. STAMP SERIAL NUMBER IN BLOCK JUST BELOW PLATE IN FIGURES 6 HIGH.
|
1 | 690 |
| 7B-3028 |
SCREW-DRIVE (4X0.187-IN)
|
2 | 690 |
